No results were found for the filter!
Long Flat Cable for Darksoft CPS1 | CPS2 |...
Need an extention for your LCD screen on the Darksoft CPS2 or Darksoft Taito Multi-F3? This is approximately 3 foot long (100cm) so you can remote mount this towards your coin door. Flat cable with the proper 7x2 female connectors...
Darksoft CPS2 Multi Kit - Champion Edition
It is our pleasure to distribute DARKSOFT'S long awaited CPS2 Multi Kit - "Champion Edition"! The Multi CPS-2 Cart can be used on an original CPS-2 B board (You have to remove all the original ROMs from the board) You can put all your...
From $599.99 *
LCD Protector for Darksoft CPS1 | CPS2 | Taito...
Need a LCD case for your Darksoft CPS2 or Taito Multi-F3? This is a 3D printed case for the LCD Selector used on the Darksoft CPS2 and Taito F3 Multi's. This case is designed to be assembled with no additional hardware, so it just snaps...
8GB Micro SD for Darksoft CPS1 | CPS2 | Taito...
Need a Micro SD for your Darksoft CPS2 or Taito Multi-F3? This is an 8GB blank Sandisk Class 4 for all your programming needs!
16GB Micro SD for Darksoft NEO GEO AES
Need a Micro SD for your Darksoft NEO GEO AES? This is an 16 GB blank Sandisk Class 4 for all your programming needs!
PCB feet for Darksoft CPS2
Need PCB feet for your Darksoft CPS2? This is a 3D printed set of feet for your Darksoft CPS2 Multi. These feet are designed to be assembled with no additional hardware, so they just snap in your case without anything else needed. Easily...
Darksoft CPS2 Torx
Need to open your case for your Darksoft CPS2 Multi install? The Torx bit is suitable for opening your CPS2 case to install your new Darksoft CPS2 Multi kit! Made from S2 Material Finish and covered with magnetic shielding
Champion Edition CPS2 Key Writing Cable
Need Key Writing Adapter Cable for your "Champion Edition" Darksoft CPS2? This is a 4 wire adapter that connects to the 6 pin headers on the kit and CN9 of you "B" board. This is approximately 4" long for easy connectivity... All units...