Top seller
No results were found for the filter!

Need to open your case for your Darksoft CPS2 Multi install? The Torx bit is suitable for opening your CPS2 case to install your new Darksoft CPS2 Multi kit! Made from S2 Material Finish and covered with magnetic shielding
$5.00 *

Need a protective 3D printed cover your Darksoft STV? A 3D Printed cartridge housing for use with Darksoft's STV Multicart for the Sega STV Titan arcade hardware. Offers a much more secure fitment of the cartridge within the housing and...
$22.50 *

Need PCB feet for your Darksoft CPS2? This is a 3D printed set of feet for your Darksoft CPS2 Multi. These feet are designed to be assembled with no additional hardware, so they just snap in your case without anything else needed. Easily...
$6.75 *

Need a Micro SD for your Darksoft CPS2 or Taito Multi-F3? This is an 8GB blank Sandisk Class 4 for all your programming needs!
$10.00 *

Need an extention for your LCD screen on the Darksoft CPS2 or Darksoft Taito Multi-F3? This is approximately 3 foot long (100cm) so you can remote mount this towards your coin door. Flat cable with the proper 7x2 female connectors...
$22.50 *

Need a LCD case for your Darksoft CPS2 or Taito Multi-F3? This is a 3D printed case for the LCD Selector used on the Darksoft CPS2 and Taito F3 Multi's. This case is designed to be assembled with no additional hardware, so it just snaps...
$17.50 *
Hot Item!

Need Key Writing Adapter Cable for your "Champion Edition" Darksoft CPS2? This is a 4 wire adapter that connects to the 6 pin headers on the kit and CN9 of you "B" board. This is approximately 4" long for easy connectivity... All units...
$14.95 *

Need a Micro SD for your Darksoft NEO GEO AES? This is an 16 GB blank Sandisk Class 4 for all your programming needs!
$12.50 *
Viewed