Need Key Writing Adapter Cable for your "Champion Edition" Darksoft CPS2?
This is a 4 wire adapter that connects to the 6 pin headers on the kit and CN9 of you "B" board. This is approximately 4" long for easy connectivity...
All units of the Champion Edition version, come with a firmware installed that allows to use original untouched romsets. In order to use them, you need to plug a cable between the main PCB of the kit and connector CN9 of your B Board. If you have one of the old type B boards, then, you'll need to solder 4 wires between this connector in the main PCB of the kit and CN2 of your B Board. Further details are given below.
We implemented the key writing process discovered and made available thanks to arcadehacker.blogspot.com/
Programming of the key is done with 4 additional signals called DATA, CLOCK, SETUP1 and SETUP2. Those signals are available in pins 2,3,4 and 5 in the connector J18 of the multi.It's located besides the microSD slot. There is a special connector, in the main PCB of the multi, so that it's very simple to connect to the same connector that you will find on your B Board. This applies to the revisions 93646B-5 and upwards. The revisions 93646B-3 and 93646B-4, don't have this connector. However you can find the very same pins available on the connector CN2.
Pinout for board revisions 93646B-3 and 93646B-4
CN2 interface pins:
- Multi connector J18 pin #2 → CN2 A32
- Multi connector J18 pin #3 → CN2 A30
- Multi connector J18 pin #4 → CN2 A31
- Multi connector J18 pin #5 → CN2 A29
Pinout for board revisions 93646B-5, 93646B-6, 93646B-7 and 97691A-3
CN9 interface pins:
- Multi connector J18 pin #2 → CN9 pin #2
- Multi connector J18 pin #3 → CN9 pin #3
- Multi connector J18 pin #4 → CN9 pin #4
- Multi connector J18 pin #5 → CN9 pin #5
What it will look like (colors on cable will be all black) -
If for any reason you need to update the firmware on your CPS2 Multi, take into account the following
DO NOT INSTALL THE WIRES UNTIL AFTER UPDATING THE FW!!!! IF THE WIRES ARE INSTALLED WHILE TRYING TO UPDATE THE FW YOU WILL CORRUPT THE
BOOT-LOADER ON THE KIT AND YOU WILL HAVE TO REWRITE IT USING A STM32F4 DISCOVERY KIT!!!
Easy way to connect!
This little cable was a lifesaver! Very easy to use and perfect for the CPS2 installation. Shipped fast and well packaged.
Simple cable needed for new CPS2 kit
Love it, thanks!
No miss, no fuss!
Easy to use