Need a LCD case for your Darksoft CPS2 or Taito Multi-F3?
This is a 3D printed case for the LCD Selector used on the Darksoft CPS2 and Taito F3 Multi's. This case is designed to be assembled with no additional hardware, so it just snaps your screen inside without anything else needed. Easily protect and seat your LCD screen inside the back of the housing and then snap the front of the case on. Easy peasy!
The case has a perfect, built in stand on the back to mount at a perfect viewing angle inside your coin door. Just remember that the standard cable that comes with the CPS2 multi is about 12 inches. We suggest that you look at our 4 foot flat cable to compliment this piece...not included with the case.
This is approximately 36 inches and allows you to place the LCD inside your control panel, coin door or anywhere you choose! (The kit comes standard with a 12 inch cable)
This is printed textured. Please see the pics. Looks way cooler than the typical 3D printed cases!
This is for the case only. Nothing else.
Official support on -
Now stop reading and go get yours!!!
Quality 3-D print.